Did you know that you can install your tile yourself? You’ve probably seen this process being done dozens of times on home improvement shows. It’s fairly easy to do on your own, even if you have little DIY knowledge or experience. All that you need is a set of easy to follow instructions, courtesy of tile floor installation Dallas.
Start By Prepping the Surface
Of course, this assumes that the old flooring has already been removed. If it hasn’t, do that first, and then begin to prep your surface. In order for the tile to sit evenly and adhere properly, your subfloor must be perfectly even, free of damage, and clean, smooth and dry. You’ll also need to take out any molding or trimming, as well as any appliances that will be in your way. Also, check your doorjambs to ensure that the tile won’t interfere with the movement of the door. You don’t want to find out too late that your door will drag on the tile, scratching it in the process. These tips can also be a great idea for your unit at https://precondo.ca/line-5-condos/.
Layout Your Tile
You’ll need a few things for this step, including a yardstick and a chalk line snapping device. Determine where the center point in the room is located and snap several chalk lines leading from the center out to each of the walls. Make sure that those lines are straight because you’ll be using them to align your tile. You don’t want to have a crooked floor! If the room is fairly large, arrange it into two foot by three-foot sections with the chalk lines. These will make it much easier to manage. Once the chalk lines are in place, start laying out tile along them, beginning at the center and radiating out towards the walls.
Generally, you want only to apply 30 minutes worth of adhesive. However many tiles you can lay in 30 minutes, use that much adhesive. Otherwise, you’ll end up with lumpy adhesive in the areas where you had to go back over the subfloor. It is okay if you can only lay a few tiles in 30 minutes. There’s no rush. Apply the adhesive to the floor in thin, even coats, and then press the tiles into it, following your grid pattern and chalk lines. Continue until your floor is covered, and cut the tiles as necessary as you go along.
It’s Time for Grout
Once your tile adhesive fully dries, it’s time to grout. The grout should be applied with a trowel in between the tiles. Use a cloth to wipe away any excess grout that ends up on the tiles. Leaving any of these marks behind will make your flooring look like an amateur did it. Even though one did, you still want it to look as professional as possible. Give the grout plenty of time to dry, and then you’re done!
If you have any questions about the tile installation process, click here to get some advice from the experts: tile floor installation Dallas.